0
Environmental & Hazmat

Cold Weather / Hypothermia Prevention

Cold weather protection including hypothermia and frostbite prevention, recognition and emergency response.

Revision 2.2 Updated Nov 6, 2026

Scope and Purpose

This procedure covers preventing, recognizing and responding to cold stress for work outdoors in cold weather and indoors in unheated or refrigerated spaces: planning, measuring temperature and wind chill, clothing, warm-up breaks and heated shelters, heaters, ice and snow, watching workers and emergency response.

Cold stress includes hypothermia, frostbite, frostnip and trench (immersion) foot. Hypothermia can happen above freezing when workers are wet, in wind or tired. Frostbite needs an actual air temperature below freezing.

Hazard Identification

  • Hypothermia (cold air, wind, wet clothing, spray, fatigue)
  • Frostbite and frostnip (exposed skin; bare skin on cold metal)
  • Trench (immersion) foot
  • Loss of dexterity and alertness leading to injuries and mistakes
  • Slips and falls on ice and snow
  • Carbon monoxide and fire from heaters
  • Cold water immersion
  • Wind, ice and snow on cranes and equipment
  • Snow and ice falling from roofs, structures and booms
  • Lone worker develops cold stress unseen

Required PPE

  • Layered clothing: an inner layer that moves sweat away from the skin (wool or synthetic; avoid cotton next to the skin because it stays wet), an insulating middle layer and a wind and water resistant outer layer (company rule). Outer layer high-visibility where vehicles or equipment move (Canada federal CSA Z96, COHSR 12.17).
  • Hard hat: US ANSI Z89.1 (1926.100); Canada federal CSA Z94.1 or ANSI Z89.1 (COHSR 12.1). Liners only if approved by the hard hat maker. No hats or hoods under the hard hat unless the maker allows them (company rule; protection equipment must not in itself create a hazard, COHSR 12.04; PPE must be of safe design, US 1926.95(c)(1)).
  • Insulated, waterproof gloves with liners suited to the task. Spare dry pair on site.
  • Insulated, waterproof safety boots with traction soles; toe protection (Canada federal CSA Z195, COHSR 12.11).
  • Face and neck covering (balaclava or neck gaiter) at the skin cover trigger. It must not break the seal of a tight-fitting respirator (US 1910.134(g)(1)(i)(B)).
  • Tinted or anti-fog eye protection for snow glare where needed (company rule).
  • Hand and toe warmers used per the maker's instructions.
  • US: the employer does not have to pay for ordinary weather clothing such as winter coats, parkas, gloves, rubber boots and hats (1926.95(d)(4)(ii)). Specialty PPE is employer-paid (1926.95(d)(1)).

Key Procedure Steps

Before the cold season

  1. Write or update the site cold stress plan.
  2. Train workers and supervisors (Section 6).
  3. Set up heated shelters, heaters and CO alarms.

Each shift

  1. Check the forecast.
  2. Apply the cold plan at an air temperature of 40 F (4 C) or colder, or during cold work with wet workers: follow steps 6 to 16.
  3. Brief the crew: level, warm-up breaks, shelter location, buddy pairs, check-in times, signs of cold stress.
  4. Clear or treat ice and snow on access routes and work surfaces before work.

While the cold plan is on

  1. Re-read temperature and wind at least every 2 hours and whenever the weather changes (company floor).
  2. Take warm-up breaks in a heated shelter on the ACGIH work/warm-up schedule.
  3. Schedule the heaviest work for the warmest part of the day.
  4. Keep dry.
  5. Warm, sweet drinks and food are available at breaks.
  6. Buddies check each other's face, ears and fingers, and watch for shivering, slurred speech, clumsiness or confusion, at every warm-up break.
  7. Lone workers check in at least every 2 hours (company floor) and before moving to a new location.
  8. At the skin cover trigger (wind chill -19 °F / -28 °C or colder): all skin covered, including the face.
  9. Heaters: supply fresh air; keep clearances from combustibles per 1926.154 Table F-4 or the heater's listing; keep heaters at least 10 ft from tarps and canvas, with the coverings fastened; set heaters level; no solid-fuel salamanders in buildings or on scaffolds; oil-fired heaters need a primary safety control that stops fuel on flame failure; test the CO alarm each shift.

At the stop-work trigger

  1. At wind chill -20 °F (-29 °C) or colder, stop non-emergency outdoor work and move everyone to shelter (company floor).

End of shift

  1. Account for every worker.

Each step is shortened to its first sentence. The full procedure, with every condition, checklist and sign-off field, is in the PDF.

Training Requirements

  • All workers: Cold stress hazards; signs of hypothermia, frostbite, frostnip and trench foot; layering and keeping dry; warm-up breaks and shelter locations; buddy system; heaters and carbon monoxide; ice and snow; what to do in an emergency; reporting.
  • Supervisors: All of the above, plus reading and recording temperature and wind chill, the company triggers, the ACGIH work/warm-up schedule, stop-work, first response and records.
  • First aiders: US: valid first aid certificate where no clinic or hospital is reasonably accessible (1926.50(c)).
  • Workers who set up or refuel heaters: Heater maker's instructions, 1926.154 rules, carbon monoxide, fuel handling.

Regulatory References

  • Occupational Safety and Health Act of 1970, section 5(a)(1) (29 U.S.C. 654(a)(1)), General Duty Clause.
  • 29 CFR 1926.21(b)(2) (training); 1926.50 (first aid); 1926.95 and 1926.100 (PPE, head protection); 1926.154 (temporary heating devices); 1926.451(f)(8) (snow and ice on scaffolds); 1926.1417(n) (wind, ice and snow, cranes); 1910.134(g)(1) (respirator seal).
  • 29 CFR 1904.39 (reporting).
  • US National Weather Service, wind chill temperature index.
  • ACGIH, TLVs and BEIs: Cold Stress. Named.
  • Canada Labour Code Part II, s. 124.
  • COHSR SOR/86-304: s. 2.14 (ice and snow), s. 3.14 (temporary structures), Part XII (12.04, 12.1, 12.11, 12.17), Part XV (reporting), Part XVI (first aid), Part XIX (hazard prevention program, training).
  • SOR/2026-10: COHSR 10.1 ("thermal stress") and 10.19.3 (thermal stress procedures), in force January 30, 2027; Maritime Occupational Health and Safety Regulations s. 255.3, same date.
  • Provincially regulated work: follow your province's OHS regulation.

Download the Full PDF Template

Get the complete Cold Weather / Hypothermia Prevention document as a fillable PDF, part of the Safe Work Procedures Template Pack.

Get Template Pack

Get This SWP + 4 More Free

Choose from 112 procedures. No credit card, no commitment.

Pick Your 5 Free SWPs

Want Digital Sign-Off for Your SWPs?

Make Safety Easy lets your crew acknowledge procedures on any device. Track who read what, when. No more lost paper forms.

Start Your Free Trial