Hammer Drill / Rotary Hammer
Hammer drill and rotary hammer use with silica dust controls and vibration management.
What This Procedure Covers
- Scope and authorization
For drilling approved holes in masonry or concrete using a handheld hammer drill or rotary hammer. Chiselling, demolition, core drilling and cutting reinforcement require separate task approval and controls.
Confirm the hole location is permitted: Identify structural restrictions and concealed services before drilling. Do not assume a clear detector reading proves that the path is safe. Stop for unknown reinforcement, post-tensioning, services or an unapproved hole location.
- Locate services and prepare the work area
Use the required drawings, surveys, detection and authorization process. Arrange service isolation and verification by the responsible qualified person where needed.
Establish stable access: Support loose workpieces and keep people clear of the exit side. Choose a stable position that allows both handles to be used without overreaching. Route cables and extraction hoses away from the bit and access path.
- Select and verify silica controls
Complete the applicable exposure-control method before drilling silica-containing material. A dust-collector label alone does not establish that the entire setup meets the required control method.
US construction Table 1 drilling method, where applicable: For the handheld/stand-mounted drill entry, use a commercial shroud or cowling with dust collection. The collector must meet the manufacturer airflow requirement, have at least 99% filter efficiency and a filter-cleaning mechanism. Use a HEPA-filtered vacuum to clean holes. Maintain the full system as instructed. That Table 1 entry does not require a respirator when its conditions are fully implemented. Other tasks, incomplete controls or other jurisdictions need their applicable assessment and respiratory requirements. Do not substitute improvised wet drilling on a tool not approved for it.
- Inspect the tool and set the mode
Disconnect the supply before changing bits or exposed adjustments. Check the body, trigger, auxiliary handle, retention system, supply and dust attachment. Reject damaged or incompatible bits.
Grip and feed for control: Use both designated handles and stable footing. Follow the bit and tool instructions for starting speed and feed; long bits must not be spun freely above their rated speed. Apply pressure in line with the hole and do not force or side-load the bit. Keep dust capture effective during drilling and the specified hole-cleaning process. Manage vibration exposure through tool condition, task duration and work organization; anti-vibration gloves do not establish a safe exposure duration.
- Binding, interruptions and completion
Stop immediately for binding, unexpected material or abnormal vibration. Torque-control features do not remove the need for a secure grip and safe stance.
Do not restart against a blocked bit: Disconnect the energy source and use the model-specific method to release or remove the bit. Do not automatically switch to drill-only mode and power out of a jam. Confirm the cause and obtain approval before continuing if reinforcement or services may have been contacted.
Cleanup and hot tooling: Allow movement to stop and handle hot bits carefully. Use the approved dust-control method for cleanup and waste collection. Do not dry-sweep or use compressed air in a way that disperses silica dust into the work area.
- Local records and follow-up
Record site additions and unresolved defects. Reassess whenever the material, hole location, tool or dust-control configuration changes.
Reference guidance: OSHA Handheld and Stand-Mounted Drills (FS-3630), Small Entity Silica Guide (3902); Bosch rotary-hammer instructions 160992A9W1 (2024) and 160992A8DR (2023). Apply the actual tool manual and local requirements.
Download the Full PDF Template
Get the complete Hammer Drill / Rotary Hammer document as a fillable PDF, part of the Safe Work Procedures Template Pack.
Get This SWP + 4 More Free
Choose from 112 procedures. No credit card, no commitment.
Pick Your 5 Free SWPsWant Digital Sign-Off for Your SWPs?
Make Safety Easy lets your crew acknowledge procedures on any device. Track who read what, when. No more lost paper forms.
Start Your Free Trial