HVAC Installation
HVAC system installation including sheet metal handling, brazing and refrigerant management.
What This Procedure Covers
- Identify the installation
Use for installation planning, ductwork and equipment placement. Refrigeration, electrical, gas, lifting and pressure-test work must follow the separate approved methods for the actual system and qualified personnel.
Identify the refrigerant before selecting equipment: Record the refrigerant designation, safety classification and SDS. Do not assume every system uses a nonflammable refrigerant. Confirm the installation, tools, ventilation and technician training are suitable for this refrigerant and equipment.
- Handle sheet metal and place equipment
Plan delivery routes, unloading and temporary storage before material arrives. Confirm equipment weight, dimensions and approved lifting points. Use suitable handling aids and trained lifting personnel; keep people clear of suspended loads.
Control edges and awkward handling: Secure sheets and duct sections against sliding or tipping. Protect exposed edges and remove burrs using the approved tools. Select cut protection for the material and task; a single glove rating is not adequate for every operation. Follow machinery instructions where gloves could be caught. Use the specified structural supports, anchors and bracing. Do not use a ceiling grid as a work platform or equipment support. Obtain approval before changing hangers, cutting structure or loading an existing support.
- Provide safe access and work-area controls
Select a platform suited to overhead work, tools and material loads. Confirm safe access, roof openings, fragile surfaces and edge protection before taking equipment onto a roof or above a ceiling.
Separate installation hazards from building users: Protect people below from falling components and tools. Establish controlled work boundaries and coordinate with adjacent trades. Keep exits, fire systems and occupied-area ventilation available, or use an approved impairment plan before disruption. Stop if drilling or removal exposes unknown services, suspect asbestos or other unassessed materials. Resolve the hazard before proceeding. A harness alone does not establish an adequate fall-protection system.
- Control joining and refrigerant work
Use the manufacturer-approved joining method and an authorized hot-work process where needed. Confirm the equipment is safe for the work through the applicable securing and refrigerant-management procedures before opening or heating it.
Match controls to the actual refrigerant: Refrigerant exposure can cause cold burns and dangerous atmospheres; flammable refrigerants also introduce ignition hazards. Heat can produce hazardous decomposition products. Do not apply flame to a charged system. Use the approved recovery and preparation method before work. In the US, verify the applicable EPA Section 608 certification and service requirements for the assigned task. Other jurisdictions have their own requirements. Certification does not replace training for the particular refrigerant, tools and equipment. Do not intentionally vent regulated refrigerant.
- Test and commission under authorization
Use the approved test and commissioning plan for this equipment. Record required conditions from the manufacturer and applicable specification; do not substitute generic pressure, duration or charging values.
Check the installed safeguards: Have a qualified person (US 29 CFR 1910.399; Canada federal COHSR 1.2; see SWP-052) complete electrical and control-system checks. Confirm guards, panels, supports and required detection or mitigation systems are installed and functional before release. Keep people clear of fans, belts and automatically starting equipment. Do not bypass a safety device to obtain a passing result. Stop commissioning for an unexplained alarm, leak, abnormal vibration or failed safeguard, and have the responsible person authorize correction and retesting. Keep the system out of service until accepted.
- Hand over the accepted installation
Provide the operator with system identification, operating restrictions, service instructions and completed test records. Confirm outstanding work and who controls any equipment that remains unavailable.
Reference guidance: EPA Section 608; IHSA Sheet Metal; ACCA A2L safety training; BCCSA sheet-metal handling guidance. Complete using local requirements and the specific equipment instructions.
Download the Full PDF Template
Get the complete HVAC Installation document as a fillable PDF, part of the Safe Work Procedures Template Pack.
Get This SWP + 4 More Free
Choose from 112 procedures. No credit card, no commitment.
Pick Your 5 Free SWPsWant Digital Sign-Off for Your SWPs?
Make Safety Easy lets your crew acknowledge procedures on any device. Track who read what, when. No more lost paper forms.
Start Your Free Trial