Impact Driver / Wrench
Impact driver and impact wrench operation with torque verification procedures.
What This Procedure Covers
- Define the fastening task
Complete for the actual tool, supply and connection. Hydraulic tensioners and hydraulic torque wrenches require their own equipment-specific procedure; this document does not cover them.
Know the acceptance requirement before starting: Record whether the task requires a specified torque, a controlled installation sequence or another approved acceptance method. An impact-tool power setting or advertised maximum output is not proof that a connection meets its specification.
- Inspect the tool and energy supply
Stop and disconnect the energy source before fitting or removing accessories. For pneumatic tools, isolate the air and release stored pressure by the manufacturer method before disconnecting or servicing.
Use controls that match the supply: For corded tools, inspect the lead and use the electrical protection required for the location. For air tools, confirm compatible couplings, hose condition, pressure rating and required hose restraints; keep hoses protected from traffic and damage. Do not exceed the tool pressure limit. Route leads and hoses to avoid trips. Assess noise and vibration exposure and plan task duration and breaks. Gloves are not a substitute for exposure controls; keep loose clothing and anything that could become entangled away from rotating parts.
- Match accessories and restrain the work
Use impact-rated bits, sockets and adapters of the correct size and drive type. Identify their rating from the manufacturer, not colour or surface finish. Reject worn, cracked or poorly fitting accessories.
Prepare for rotation and release: Secure work that could move or rotate. Plan where loosened fasteners and components will go; support loads before releasing their fixings. Maintain a stable stance with hands clear of rotating sockets and pinch points. Use the designated grips and any required auxiliary handle. Where a fastener could contact concealed wiring, follow the tool instructions for insulated gripping surfaces and establish the service location before work. Stop if the intended fastening path cannot be confirmed safe.
- Operate and verify the connection
Check direction and the model-specific operating mode before contact. Seat the accessory fully and keep it aligned. Use controlled operation; stop if the socket slips, the fastener binds or the tool behaves abnormally.
Verification follows the joint specification: Where a tightening torque is specified, use the specified verification method and suitable calibrated equipment. Do not treat impact duration, sound or a mode selector as a torque measurement. For structural bolts and other engineered connections, follow the approved installation and inspection procedure; an arbitrary final torque check cannot replace it. Do not continue hammering to compensate for damaged threads, a wrong fastener or a connection that will not seat. Stop, identify the cause and obtain the required corrective instruction before proceeding.
- Shutdown, exceptions and records
Release the trigger and wait for movement to stop. Disconnect the energy source before accessory changes or maintenance. Store the tool and accessories securely and quarantine defective equipment.
Reference guidance: Bosch impact-tool instructions 160992AA02 (2024); CCOHS Pneumatic Tools; RCSC Specification for Structural Joints Using High-Strength Bolts (2020). Apply the actual tool manual and approved joint specification.
Download the Full PDF Template
Get the complete Impact Driver / Wrench document as a fillable PDF, part of the Safe Work Procedures Template Pack.
Get This SWP + 4 More Free
Choose from 112 procedures. No credit card, no commitment.
Pick Your 5 Free SWPsWant Digital Sign-Off for Your SWPs?
Make Safety Easy lets your crew acknowledge procedures on any device. Track who read what, when. No more lost paper forms.
Start Your Free Trial