0
Power Tools

Reciprocating Saw Operation

Reciprocating saw operation for demolition and remodeling with hidden utility awareness.

Rev 02 Updated Apr 19, 2026

What This Procedure Covers

  1. Task and authorization

    Complete for the actual saw, material and cut. Structural demolition and work affecting services need their own approved assessment before this tool procedure can be used.

    Define what may be cut: Identify whether the material supports a load or contains stored energy. Do not cut structural members, pressurized lines or unknown assemblies under this generic procedure without a specific approved plan. Plan for the cut section to move or fall.

  2. Establish a clear cutting path

    Confirm what is within and beyond the full blade travel. A detector indication alone is not permission to cut or proof that wiring is de-energized.

    Unknown materials or concealed services: Stop where the cut path or material cannot be identified. Obtain the necessary investigation and authorization before continuing. Assess coatings and dust-producing materials for hazards such as lead, asbestos or silica and use the applicable exposure-control procedure; a generic dust mask entry is not an adequate assessment.

  3. Inspect and set up

    Disconnect the supply or remove the battery before blade changes and exposed adjustments. Check the trigger, housing, shoe and blade-retention mechanism and remove defective tools from use.

    Blade length and clearance: Select a blade that projects beyond the work throughout its stroke, while maintaining clearance behind the cut. A blade tip striking the far side can cause loss of control. Set the shoe and operating mode as specified for the tool and material. Keep bystanders outside the cutting area. Secure the work instead of holding it against your body. Arrange the cord and any extraction hose clear of the blade and the operator path.

  4. Make the cut and manage interruptions

    Use the designated grips, normally both hands, with the supporting shoe against the work during cutting. Keep hands away from the blade and underside of the material.

    Controlled feed: Start with the blade clear of the material using the model-specific starting method. Use the prescribed speed and moderate feed; do not force the blade or twist it in the kerf. Maintain support as the cut finishes and control the separated piece.

    Plunge cutting is a separate setup: Use a plunge cut only where the actual saw instructions permit it for the material and selected blade. Do not plunge cut metal. Record the permitted entry method; otherwise use an approved edge entry or starter opening. Never plunge into an unverified concealed space. If binding occurs, release the trigger and wait for the blade to stop. Disconnect the energy source before freeing the blade or changing the setup. Do not pull a moving blade from a jam. Stop for unexpected movement, unusual vibration or damaged teeth.

  5. Shutdown and follow-up

    Wait for the blade to stop before withdrawing it or setting the saw down. Handle hot or sharp blades carefully. Disconnect the energy source before removal, cleaning or maintenance.

Reference guidance: CCOHS Saws - Sabre, Jig and Reciprocating; Bosch reciprocating-saw instructions 2610027769 (2012) and GSA12-30 160992A9S8 (2024). Use the actual model instructions and site cut-path assessment.

Download the Full PDF Template

Get the complete Reciprocating Saw Operation document as a fillable PDF, part of the Safe Work Procedures Template Pack.

Get Template Pack

Get This SWP + 4 More Free

Choose from 112 procedures. No credit card, no commitment.

Pick Your 5 Free SWPs

Want Digital Sign-Off for Your SWPs?

Make Safety Easy lets your crew acknowledge procedures on any device. Track who read what, when. No more lost paper forms.

Start Your Free Trial