Roofing Nail Gun
Roofing nail gun operation with combined fall protection and power tool safety.
What This Procedure Covers
- Scope and work authorization
For roofing nailers used with compatible roofing fasteners and materials. Complete alongside the site roof-access and fall-protection plan; this tool procedure alone does not authorize roof work.
Confirm the tool and material match: Check nail dimensions, collation and coating against both the tool and roofing specifications. Record the required placement, penetration and seating. A roofing nailer is not automatically suitable for every membrane, flashing or substrate.
- Roof access and protection
Inspect deck condition, access, openings, skylights, edges and weather before bringing the tool onto the roof. Do not work from an unstable, slippery or otherwise unsafe surface.
Plan movement and emergency response: Provide the fall-prevention or protection system required for the task and location, including a workable rescue arrangement where fall arrest is used. Keep protection effective during access, work and descent. Changing trigger mode does not make a wet or unsafe roof acceptable. Use an appropriate method to raise and lower equipment; do not carry an operating tool while climbing or hoist it by its hose. Keep people clear of the area below and of spaces where nails could penetrate the deck.
- Inspect, load and test
Check the trigger, contact mechanism, magazine, feed system and nose. Use full sequential actuation for this procedure and verify operation before fastening on the roof.
Set up using the actual manual: Follow the model-specific loading and supply-connection sequence. Set the magazine platform for nail length where required, secure the feed and magazine covers, and keep the trigger and contact unactuated while loading. Never defeat a contact safety or use the tool with a damaged feed mechanism. Route the hose clear of access and fall-protection lines, with enough controlled slack to avoid pulling the operator. This tool can create sparks; keep it away from flammable vapours and coordinate with adhesive, solvent and hot-work activities.
- Fasten and manage interruptions
Maintain a secure position within the protected work area. Use eye and hearing protection suited to the task. Keep hands and coworkers out of the nail path, including the underside of the deck.
Deliberate placement: Seat the contact correctly, actuate the sequential trigger and reset before the next shot. Keep the trigger finger clear when moving. Follow the roofing nail pattern and inspect for proud, overdriven or misplaced fasteners; correct them by the approved roofing method.
Jam or loss of safe footing: Stop work and move to a safe position using the site access plan. For jam clearance, disconnect the power source and unload as instructed before opening or servicing the tool. Account for stored energy. Repeated jams or unreliable actuation require removal from service. Do not leave a tool where it can slide off the roof. Report all unintended discharges and injuries; obtain prompt medical attention for nail penetration.
- Shutdown and records
Disconnect, unload and secure the tool according to the manual. Collect loose fasteners and packaging without compromising fall controls. Inspect the work and clear the exclusion area only when safe.
Reference guidance: BOSTITCH RN46 instructions 149946 Rev D; NIOSH Nail Gun Safety; OSHA roof-repair/re-roofing fact sheets; CCOHS Roofing - Residential. Use the actual tool manual, roofing specification and site fall plan.
Download the Full PDF Template
Get the complete Roofing Nail Gun document as a fillable PDF, part of the Safe Work Procedures Template Pack.
Get This SWP + 4 More Free
Choose from 112 procedures. No credit card, no commitment.
Pick Your 5 Free SWPsWant Digital Sign-Off for Your SWPs?
Make Safety Easy lets your crew acknowledge procedures on any device. Track who read what, when. No more lost paper forms.
Start Your Free Trial