0
Heavy Equipment

Telehandler / Zoom Boom

Telehandler operation with variable load chart interpretation, tip-over prevention and work platform use.

Rev 02 Updated Apr 19, 2026

What This Procedure Covers

  1. Machine and task authorization

    For material handling with the identified telehandler and approved attachment. Rotating machines, suspended loads and personnel platforms require their additional task-specific plans and qualifications before use.

    Authorization follows the actual equipment: Do not assume a general forklift card authorizes every telehandler configuration. Confirm training, evaluation and any licensing requirements for the machine, attachment and activity in the applicable jurisdiction.

  2. Pre-use inspection and configuration

    Inspect before use using the manufacturer checklist. Check the chassis, tires, boom, attachment coupler, hydraulic system and protective structures, then test operating and safety functions as prescribed.

    The chart must match the setup: Confirm a legible load chart for the exact machine and attachment, including any tire, stabilizer or other configuration requirements. Do not lift without the correct chart. A load indicator is not a substitute for reading and applying it.

  3. Ground, route and work-zone preparation

    Assess bearing capacity, slopes, excavations, buried voids and changes in surface condition. Identify overhead obstructions and establish the required electrical clearances before moving the boom.

    Level and support as the chart requires: Position and level the machine using its instructions before raising the load. Set stabilizers and pads where required by the selected configuration. Do not deploy them merely as an improvised response to instability, and do not use chassis sway to level an elevated load. Separate pedestrians from travel and placement areas. Keep spotters out of crush zones and never between the machine and a load or structure. Stop when the operator loses the agreed communication or clear view.

  4. Plan the lift and place the load

    Establish load weight, centre of gravity and security. Determine the required height and reach through the whole movement, not just at pickup.

    Operate within every part of the chart: Keep the machine in its approved configuration and use smooth controlled movements. Do not drag or side-pull loads. Check destination support and capacity before placement and keep everyone clear of the suspended or elevated load. Travel with the boom and load in the manufacturer travel position, low and retracted as instructed. Do not substitute a universal 300 mm height for every machine or surface. Follow the specified grade, steering and visibility arrangements.

  5. Instability and special attachments

    Stop for an alarm, shifting load, ground movement or unexpected wheel lift. Keep people clear and follow the manufacturer recovery instructions; do not improvise a boom movement or assume lowering always improves stability.

    Suspended loads: Use only an approved attachment with the correct suspended-load chart and a task-specific plan. Include lifting accessories in the load calculation and address swing, wind, travel and communication. Applicable crane or lifting rules may introduce additional requirements.

    Personnel platforms: Never lift people on bare forks, pallets or an unapproved platform. A platform attachment needs an approved machine combination, controls, fall-protection arrangements and an emergency-lowering plan. Do not assume one operator-position or tie-off rule covers every system.

  6. Parking and local records

    Park on suitable ground in the designated area. Follow the manual sequence to retract and lower the boom or attachment, manage stabilizers, apply the brake and shut down. Secure against unauthorized use.

Reference guidance: Genie Telehandler Load Charts and Safety Tips; HSE Telescopic Handlers; WorkSafeBC Telehandlers and rotating-telehandler guidance. Apply the actual machine/attachment manuals, charts and local requirements.

Download the Full PDF Template

Get the complete Telehandler / Zoom Boom document as a fillable PDF, part of the Safe Work Procedures Template Pack.

Get Template Pack

Get This SWP + 4 More Free

Choose from 112 procedures. No credit card, no commitment.

Pick Your 5 Free SWPs

Want Digital Sign-Off for Your SWPs?

Make Safety Easy lets your crew acknowledge procedures on any device. Track who read what, when. No more lost paper forms.

Start Your Free Trial