Angle Grinder Operation
Angle grinder safety including disc selection, guard use and fire prevention.
What This Procedure Covers
- Approve the tool, accessory and task
Complete for the actual grinder and accessory using both manufacturers’ instructions. This template supports trained operators; it does not authorize an unapproved attachment or substitute for practical instruction.
Define the scope: Confirm the tool is intended for the operation. Grinding, cutting, brushing and other tasks can require different guards and accessories. Do not assume a disc that physically fits is suitable. Assess coated metals, masonry and other dust-producing work before starting.
- Inspect and mount before use
Keep defective tools and accessories out of service. Disconnect the energy source using the tool instructions before changing an accessory, adjusting a guard or performing an authorized inspection that could expose moving parts.
Compatibility and condition: Verify accessory type, diameter, mounting and speed rating for the grinder. The accessory’s maximum permitted speed must not be below the tool’s applicable maximum speed. Inspect for damage and required expiry or storage limits. Use the specified flanges and mounting method; do not enlarge a hole or force a fit.
Tool readiness: Check the guard, handle, switch, housing and power supply for defects. Carry out only the prescribed inspection and run checks. Stand clear of the accessory’s plane during the instructed trial run and stop for unusual vibration, noise or wobble. Do not apply a ring-test method to a wheel type it does not suit.
- Prepare the work area and controls
Secure and support the work so it cannot shift or pinch the accessory. Plan a stable stance and clear movement path. Protect nearby workers from sparks, fragments, noise and dust.
Keep clothing, hair, jewellery and cords clear of moving parts. Select PPE for the assessed task and compatible use. Where hot-work controls are required, confirm them before starting, including a fire watch for at least 60 minutes after work ends (company rule; the OSHA minimum is 30, 1910.252(a)(2)(iii)(B)) and the post-work checks; an extinguisher nearby does not replace those arrangements.
- Operate within the approved method
Maintain the specified grip, handle use and body position. Follow the accessory instructions for contact angle, feed direction, speed and permitted surface. Keep hands and the power lead clear of the working accessory.
Control contact and kickback: Allow the tool to reach the instructed operating condition before contact. Avoid twisting, jamming or excessive pressure. Do not side-grind with an accessory intended only for cutting. Keep clear of the potential kickback path and use the task’s planned work support. Do not remove a guard to make the tool fit.
If it binds or behaves abnormally: Stop using the tool and follow its shutdown and energy-disconnection instructions before addressing the cause. Do not pull a rotating cutting wheel from a bind or restart it while trapped. A damaged or suspect accessory must be assessed and replaced as required before work resumes.
- Finish, store and record concerns
Keep control until the accessory has fully stopped before setting the tool down. Make hot workpieces safe to handle, complete the required fire checks and clean up using the approved dust-control method.
Reference guidance: CCOHS Use of Portable Grinders and Wheel Mounting; Bosch Professional Angle Grinders / Application; SafeWork NSW Safe use of abrasive wheels. Complete against the actual tool and accessory instructions and local requirements before approval.
Download the Full PDF Template
Get the complete Angle Grinder Operation document as a fillable PDF, part of the Safe Work Procedures Template Pack.
Get This SWP + 4 More Free
Choose from 112 procedures. No credit card, no commitment.
Pick Your 5 Free SWPsWant Digital Sign-Off for Your SWPs?
Make Safety Easy lets your crew acknowledge procedures on any device. Track who read what, when. No more lost paper forms.
Start Your Free Trial