Painting and Coating

Scope and Purpose

Painting and coating operations with spray safety, ventilation and respiratory protection. This safe work procedure establishes the minimum safety requirements for Painting and Coating operations. It applies to all workers, contractors and visitors who may be involved in or exposed to these activities.

Hazard Identification

• Falls from elevation or through openings
• Struck-by hazards from falling materials or tools
• Crush injuries from heavy materials
• Exposure to airborne dust and silica
• Musculoskeletal injuries from manual handling
• Noise-induced hearing loss

Required PPE

Key Procedure Steps

1. Review this safe work procedure and ensure all workers understand the scope and hazards before starting.
2. Conduct a pre-task hazard assessment (tailboard/toolbox talk) specific to the work area and conditions.
3. Inspect all required PPE and equipment. Remove any defective items from service immediately.
4. Establish the work area with appropriate barricades, signage and access controls.
5. Perform the task following the step-by-step instructions in the full procedure document.
6. Monitor conditions continuously. Stop work if conditions change or new hazards are identified.
7. Clean up the work area, properly store equipment and complete all required documentation.

Training Requirements

All workers performing Painting and Coating activities must complete task-specific training before beginning work. Training must cover hazard recognition, PPE selection and use, emergency procedures and the steps in this SWP. Refresher training is required annually or whenever the procedure is updated. Competency must be verified by a qualified supervisor before workers are authorized to perform these tasks independently.

Regulatory References

• OSHA 29 CFR 1926 - Safety and Health Regulations for Construction
• CSA Z460 - Control of Hazardous Energy
• ANSI/ASSE A10 - Safety Requirements for Construction
• Local building code requirements